tech:3d_prusa
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tech:3d_prusa [2016/02/13 19:20] – bullar | tech:3d_prusa [2016/02/21 21:25] (current) – [Printer Trouble] bullar | ||
|---|---|---|---|
| Line 26: | Line 26: | ||
| |offset print area| | |offset print area| | ||
| |offset extruder 2| 27| 0| 0| mm| | |offset extruder 2| 27| 0| 0| mm| | ||
| + | |||
| + | ==== Printer Trouble ==== | ||
| + | |||
| + | [[https:// | ||
| + | [[http:// | ||
| ==== CURA Setup ==== | ==== CURA Setup ==== | ||
tech/3d_prusa.1455391253.txt.gz · Last modified: 2016/02/13 19:20 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
