Translations of this page?:
TechWiki
GW60 Rollo
- GW60 Superrollo
- Hardware
- Programming
- S/W extension
- TRADFRI Modul
- Modul H/W
- Programming
- Tools
- GW60 TRADFRI adapter
- Schematic
- Programming adapter
- Housing
- Integration
Sidebar
tech:3d_prusa
This is an old revision of the document!
Prusa i3
Setup Bed
| Item | X | Y | Z | Unit |
|---|---|---|---|---|
| max values | 235 | 245 | 180 | mm |
| bed size | 214 | 214 | - | mm |
| print area | 190 | 190 | 180 | mm |
| offset bed | 28 | 24 | 0 | mm |
| offset print area | 40 | 38 | 0 | mm |
| offset extruder 2 | 27 | 0 | 0 | mm |
tech/3d_prusa.1455384304.txt.gz · Last modified: 2016/02/13 17:25 by bullar
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
