Translations of this page?:
TechWiki
GW60 Rollo
- GW60 Superrollo
- Hardware
- Programming
- S/W extension
- TRADFRI Modul
- Modul H/W
- Programming
- Tools
- GW60 TRADFRI adapter
- Schematic
- Programming adapter
- Housing
- Integration
Sidebar
tech:airfilter
This is an old revision of the document!
Table of Contents
Laser cutter fume extractor
Based on idea from Zach
Material
| Qty | Part | Cost |
|---|---|---|
| 1 qm | Foam Air Conditioner Filter  6mm thick G3 | 10,00 € |
| 1 qm | Filtervlies  F7/F9 | 15,00 € |
| 1 | HEPA filter HEP-5018E  H13 Drawing Specification | 69,95 € |
| 10kg | Activated carbon  0.5-2.5mm grain diameter (cocunut) | 70,00 € |
| 2 qm | Polyester Air Filter  20mm thick G4 | 30,00 € |
| 1 | Neoprene shelving liner  3mm thick soft | |
| 1 | Stainless mesh  6mm mesh, 1mm wire width | |
| 1 | Insect mesh  | |
| 1 | Weather stripping  |
Filter Layer
from outside to inside (inverted air flow):
- Polyster Air Filter (200 x 1445 mm)
- Stainless mesh (200 x 1445 mm)
- Insect mesh (200 x 1445 mm)
- Activated carbon (12.9 liter)
- Insect mesh (200 x 1131 mm)
- Stainless mesh (200 x 1131 mm)
- HEPA filter
- 3M Filtrete (2 layer) (200 x 880 mm)
- Stainless mesh (200 x 440 mm)
- Foam Air conditioner filter (200 x 440 mm)
tech/airfilter.1482686929.txt.gz · Last modified: 2016/12/25 17:28 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
